- Address:
26 Elizabeth St, South River, NJ 08882
- Email:
mail@truck-repair-nj.com
- Phone line:
+1 (347) 656-62-73
Truck transmission repair (rebuild)
Torque is transmitted via the drive shaft to the axle gearbox of the truck. The gearbox, depending on the type of operation, experiences maximum loads in operation.
Timely diagnostics and adjustment of the gearbox will extend the service life of this unit and delay the repair of the gearbox.
WHAT YOU RECEIVE ?
FLAT RATE
You always know how much the repairs will cost you before we start
ORGIGNAL PARTS
We do not use cheap, unoriginal spare parts to save on repairs
FREE DIAGNOSTICS
If you repair with us, diagnostics are free
WARRANTY FOR WORK
We provide a guarantee for our repair work
Gearbox malfunction symptoms:
- Extraneous noise is heard in the gearbox;
- Oil drips are visible on the gearbox;
- Leakage of lubricants from the gearbox;
- The backlash of the shank exceeds the permissible limits;
- The gearbox began to work intermittently;
Our Truck Repair Service center repairs rear axle gearboxes for trucks of all brands, including small commercial vehicles and minibuses.
We perform gearbox repairs as follows:
- Gearbox diagnostics and repair by experienced specialists;
- Dismantling and cleaning the gearbox;
- We replace all parts, oil seals and consumables;
- Gearbox adjustment;
- We carry out a comprehensive check of the gearbox;
- Installation of a gearbox on a truck;
With TRUCK REPAIR SHOP our clients receive comprehensive truck transmission repair (automatic and manual) at attractive prices and with a real guarantee for the work performed. Our specialists have vast experience and modern tools that will quickly and efficiently repair the rear axle gearbox in trucks of all types and brands.
Call us for your gearbox diagnostics and repair today!
Parts | ||
---|---|---|
Gearbox air lines | Propeller shaft (front) | Shift selector |
Gearbox complete | Propeller shaft with center bearing | Transmission components |
Gearbox mounting | Propeller shaft, support bearing mounting parts | Yoke (axle) |
Gearbox oil cooler | Propeller shaft, intermediate | Yoke (gearbox) |
Gearbox oil cooler piping | Propeller shaft, support bearing mounting parts | Air lines, differential lock (wheels) |
Gearbox, clutch housing | Rear axle assembly | Clutch |
Gearbox, filter | Rear axle, breather | Axle brake assembly |
Gearbox, housing (rear) | Gearbox, selector unit | Clutch Pedal |
Gearbox, housing front | Gearbox, reverse shaft | Control housing (automatic gearbox) |
Gearbox, input shaft | Gearbox, output shaft | Countershaft |
Gearbox, main shaft | Gearbox, oil pump | Flywheel bearing (gearbox) |
Service | Estimated Time |
---|---|
Electronic control unit (ECU) gear selector, replace | < 0,5 hour |
Clutch sticking, test | < 0,5 hour |
Stud, axle shaft, replace (each) | < 0,5 hour |
Oil return pipe, cooler, replace (at gearbox). Gearbox removed | < 0,5 hour |
Oil supply pipe, cooler, replace (at gearbox). Gearbox removed | < 0,5 hour |
Drain / fill plug, replace (check and fill included) | < 0,5 hour |
Gearbox, calibration. Gearbox removed | < 0,5 hour |
PWM valves clutch, activation, test | < 0,5 hour |
Input signals for gear selection, test | < 0,5 hour |
Solenoid valve, brake counter shaft, test | < 0,5 hour |
Clutch cylinder, test | < 0,5 hour |
Clutch, gearbox, pulling position, calibration | < 0,5 hour |
Gear selector cylinder 1/reverse gear, test | < 0,5 hour |
Gear selector cylinder 2/3, test | < 0,5 hour |
Gears, test | < 0,5 hour |
PWM valves, clutch, test | < 0,5 hour |
Range cylinder, test | < 0,5 hour |
Split cylinder, test | < 0,5 hour |
Fitting, oil line, replace | 0,5 hour |
gasket, cover, replace | 0,5 hour |
Stud, axle shaft, replace (each) | 0,5 hour |
Gearbox, calibration | 0,5 hour |
Transmission, inspect | 0,5 hour |
Clutch cylinder, replace. Gearbox removed | 0,5 hour |
Supply hose, clutch cylinder, replace. Gearbox removed | 0,5 hour |
Oil cooler pipe, fitting or seal, repalce. Gearbox removed | 0,5 hour |
Oil cooler, replace. Gearbox removed | 0,5 hour |
Propeller shaft front, remove-install | 1 hour |
Propeller shaft intermediate, remove-install | 1 hour |
Propeller shaft rear, remove-install | 1 hour |
Breather vent, replace | 1 hour |
Gears activation, control housing (for remove/install) | 1 hour |
Air pressure sensor, test | 1 hour |
Gearbox speed sensors, test | 1 hour |
RVXX1406, Transmission control module, programming | 1 hour |
Cable harness, outside gearbox, replace | 1 hour |
Clutch, adjust | 1 hour |
Clutch pedal return spring, replace | 1 hour |
Range cylinder, overhaul | 1 hour |
Wiring harness, gear selector, replace | 1 hour |
Bracket, drive shaft support, replace | 1 hour |
Axle shaft, re-seal | 1 hour |
Drive shaft, replace (one) | 1 hour |
Solenoid valve, brake counter shaft, test. Gearbox removed | 1 hour |
Linkage, gearbox, adjust | 1 hour |
Extract broken drive shaft bolt (each) | 1 hour |
Cover, oil filter housing, replace | 1 hour |
Drive shaft, replace. Interaxle | 1 hour |
Drive shaft, replace. Rear | 1 hour |
Electronic clutch actuator (ECA), replace | 1,5 hour |
Fastener, gearbox yoke, re-torque | 1,5 hour |
Clutch brake fastener, torque | 1,5 hour |
Universal joint, replace | 1,5 hour |
Electronic clutch actuator, replace | 1,5 hour |
Flange yoke, drive axle, replace | 1,5 hour |
Main shaft and countershaft, adjust. Gearbox removed | 1,5 hour |
Companion Flange, Replace | 2,5 hour |
Input shaft sealing ring, replace | 2,5 hour |
Output shaft sealing ring, replace | 2,5 hour |
Clutch release fork, replace | 2,5 hour |
Carrier debris, clean | 2,5 hour |
Bearing, drive shaft carrier, replace | 2,5 hour |
Intermediate bearing, replace | 3 hour |
Shaft, inter-axle thru shaft, replace | 3,5 hour |
Power take-0ff, remove | 4 hour |
Gearbox, replace (short). Gearbox removed | 5 hour |
Gearbox cooler oil lines, replace (all) | 7 hour |
Gearbox, replace (Basic) | 8 hour |
Control housing, replace | 8 hour |
Position sensor, range/split/gear selector, replacement | 9 hour |
Gearbox, replace (Short) | 11 hour |
Range synchronizer, replace | 12 hour |